Table of Contents
Advertisement
Checking the Serverboard Setup
After you install the StorTrends 1300 in the rack, you will need to open the top cover to
make sure the server board is properly installed and all the connections have been made.
Step
Step 1: Accessing the
inside of the system
Step 2: Check the CPUs
(processors)
Step 3: Check the
system memory
Step 4: Installing add-
on cards
Step 5: Check all cable
connections and airflow
14
StorTrends® 1300 User's Guide (StorTrends iTX version 2.7)
Description
First, grasp the two handles on either side and pull the system
straight out until it locks (you will hear a "click"). Next, depress the
two buttons on the top of the chassis to release the top cover (1).
Push the cover away from you (toward the rear of the chassis) until it
stops (2). You can then lift the top cover from the chassis to gain full
access to the inside of the server.
To remove the system from the rack completely, depress the locking
tabs in the chassis rails (push the right-side tab down and the left-
side tab up) to continue to pull the system out past the locked
position.
You may have one or two processors already installed in the server
board. Each processor needs its own heatsink.
Your server system may have come with system memory already
installed. Make sure all DIMMs are fully seated in their slots.
If desired, you can install add-on cards to the system.
Make sure all power and data cables are properly connected and not
blocking the chassis airflow.
Advertisement
Table of Contents
