Table of Contents
Advertisement
Control Panel : Alerts : SNMP Alert Settings Page
To enable SNMP Alerts notification, left click on the box next to 'Enable SNMP alert
notification'. You can configure up to four Target IP addresses.
Field/Item
Description
Community Name
This column allows you to enter the Community name for each of the SNMP destinations
1 through 4.
Target IP
This column allows you to enter the IP address of the targets for the SNMP traps.
Add button
Left click this button to add the SNMP destination.
Delete button
This button allows you to delete a selected item from the list.
Information box
Check this box to trigger an SNMP alert notification to be sent whenever an informational
event is recorded. An Information event can be an event such as a system reboot.
Warning box
Check this box to trigger an SNMP alert notification to be sent whenever a warning event
is recorded. Examples of Warning events are: heat threshold exceeded, fan speed too slow,
and so on.
Critical/Fatal box
Check this box to trigger an SNMP alert notification to be sent whenever a critical or fatal
event is recorded. A Critical or Fatal event can be an event such as a hard disk drive
failure.
Apply button
To save changes, left click the Apply button.
Restore button
Left click this button to reload current settings.
134
StorTrends® 1300 User's Guide (StorTrends iTX version 2.7)
Advertisement
Table of Contents
