The Slave nodes must also be configured through the ManageTrends using the UPS
configuration page by specifying the mode as "Slave" and entering the Master IP address.
The screenshot of configuring the slave node is shown below.
Configuring Slave Boxes
The status of the UPS can also be monitored using the CLI. The following examples
show how to use the CLI to find the type of UPS connected and monitor the status of it.
Monitoring UPS through CLI
[root@ITX003048841e04 ~]# cli get -i
Model
Smart-UPS 1000
Status
AC Power
Load
63 %
Battery charge
100 %
Time left
016 min
Mode
Master/Single
Success.
[root@ITX003048841e04 ~]# cli get -i -m
Min Bat charge
45 %
Timeout
10 min
Mode
Master/Single
Graceful
shutdown enable YES
Success.
ups
ups
Appendix H : UPS Configuration 293