Table of Contents
Advertisement
Installing the Server into a Telco Rack
To install the StorTrends 1300 into a Telco type rack, use two L-shaped brackets on
either side of the chassis (four total). First, determine how far the server will extend out
the front of the rack. Larger chassis should be positioned to balance the weight between
the front and the back. If a bezel is included on your server, remove it. Attach the two
front brackets to each side of the chassis, then the two rear brackets positioned with just
enough space to accommodate the width of the Telco rack. Finish by sliding the chassis
into the rack and tightening the brackets to the rack.
Chapter Two : Chassis Set Up
13
Advertisement
Table of Contents
