ZyXEL Communications ZyWALL 1050 Release Note page 62

www.zyxel.com
Firmware upgrade
With the enhancement, there will be "Boot Status" in "System Status" section to indicate if
the configuration or firmware upgrade is applied successfully. If the message in "Boot Status"
is marked red, it means configuration is not applied successfully and device may skip
incorrect configuration or use last-good.conf or system-default.conf to bootup.
15. [BUG FIX] 070713769
Symptom:
The Client Virtual Desktop Logo disappeared after upgrading firmware from b6 to b7.
Condition:
1. In b6 firmware, upload a JPG file to replace default ZyXEL logo.
2. A user login SSL VPN could see the JPG picture.
3. Upgrade firmware from b6 to b7, the logo become to ZyXEL default.
16. [BUG FIX] 070709327
Symptom:
Address object reference count always increase.
Condition:
1. Add a address object
2. Policy route, IPSec policy and outbound SNAT can use this address object
3. Check CLI command "show address-object", that address object reference count are
increasing
17. [BUG FIX] 060622330
Symptom:
All configurations of Backup ZW1050 are gone after Master ZW1050 applies a new
configuration file.
Condition:
1. Master ZW1050 and Backup ZW1050 are doing Device HA with LAN and WAN
VRRP groups.
2. Backup ZW1050 will automatically sync to Master ZW1050 every one minute.
3. After applying a new configuration file on Master ZW1050:
Master: HA status of LAN is Active but HA status of WAN is N/A
Backup: HA status of LAN is Stand-By but HA status of WAN is Active
4. All configurations of Backup ZW1050 are gone after disable VRRP group of WAN on
Backup.
18. [BUG FIX] 070214194
Symptom:
Wish SSL VPN can support MacBook as a remote client.
Condition:
Wish SSL VPN can support MacBook as a remote client.
19. [BUG FIX] 070419813
Symptom:
Content Filter Cache TTL issue.
Condition:
1. GUI -> Anti-X -> Content Filter -> Cache
2. Change the Maximum TTL as 167
62/142