ZyXEL Communications ZyWALL 1050 Release Note page 128

www.zyxel.com
In CLI configuration, the following two examples of commands is supported:
Router(config)# ip virtual-server VR1 interface ge2 original-ip any map-to 192.168.3.2 map-
type any
Router(config)# show ip virtual-server
virtual server: VR1
active: yes
interface: ge2
original IP: any, netmask 255.255.255.255 mapped IP: 192.168.3.2
mapping type: any, protocol type: any
original start port: none, original end port: none
mapped start port: none, mapped end port: none
Router(config)# ip virtual-server VR1 interface ge2 original-ip 1.1.1.1 netmask 255.255.255.0
map-to 192.168.3.2 map-type any
Router(config)# show ip virtual-server
virtual server: VR1
active: yes
interface: ge2
original IP: 1.1.1.1, netmask 255.255.255.0 mapped IP: 192.168.3.2
mapping type: any, protocol type: any
original start port: none, original end port: none
mapped start port: none, mapped end port: none
128/142