ZyXEL Communications ZyWALL 1050 Release Note page 111

www.zyxel.com
Symptom:
1. There is no user type information while display user profile
2. Need to show user type while displaying user profile to improve the usability
Condition:
N/A
25. [EXTERNAL][ENHANCEMENT]
Symptom:
Support to configure DPD output idle timeout by CLI
Condition:
1. The VPN DPD detection is 8 minutes default. It is too long. The ZyNOS default
is 120 sec and it can be configured.
2. The ZW1050 can't be configured and default is 8 minutes. The DUT must wait 8
minutes at most to know peer was dead. The time is too long.
26. [EXTERNAL][ENHANCEMENT]
Symptom:
Support logging with destination IP.
Condition:
Support user logging with destination IP, including every login and logout event
log.
27. [BUG FIX] 061003100
Symptom:
Only one SA can be built-up when using remote dial-in VPN
Condition:
ZW1050 -- ZW70
1. ZW1050 creates a remote dial-in VPN rule
2. 70 creates three tunnels to dial
3. The new connected tunnel will cause the previous tunnel disconnected.
28. [BUG FIX] 060828554
Symptom:
Help page of Wizard "Two ISP" error.
Condition:
1. Click Wizard, and select "INSTALLATION SETUP, TWO ISP".
2. The Help page show "Step 2" for first page, it should be Step 1.
3. Also, in step3 and step4, the help page still show "Step2"
29. [BUG FIX] 060928880
Symptom:
IDP cannot drop ICMP echo packet when adding a custom rule with ICMP type = 8
Condition:
1. Add a custom signature with ICMP type = 8
2. Add a NONE profile with enable the custom signature (enable, drop)
3. Bind the profile on WAN, and ping from LAN to WAN no packet will be
dropped
4. If we add a custom signature with TCP dst port = 21, drop this rule can work.
111/142