ZyXEL Communications ZyWALL 1050 Release Note page 16

www.zyxel.com
In Log setting, cannot change ZySH log of system log to "enable normal and debug logs"
message.
Condition:
1. In ZyWALL > Maintenance > Log > Log Setting, Click the "Active Log Summary"
button
2. Log category: ZySH, select the system log to "enable normal logs and debug logs".
Then click OK.
3. Check the Active Log Summary, the setting will still be "enable normal log".
31. [BUG FIX] SPR ID: 080423043
Symptom:
From GUI virtual server page to firewall page will pop error message.
Condition:
1. Login GUI using Firefox
2. Create a virtual server rule and click "Configure Firewall" to link to firewall page.
3. In firewall page, there will be an error
32. [BUG FIX] SPR ID: 080708372
Symptom:
When virtual server rule has the same name as its referenced object, running config will
mess up.
Condition:
1. Create a virtual server rule as name vr1. And set map-ip as an address object with the
same name with virtual server rule, vr1.
2. Go to address object vr1, and change its name to vr2.
3. Show running config, the virtual server name is changed to vr2. But its map-ip is still
vr1.
33. [BUG FIX] SPR ID: 080718274
Symptom:
ZySH daemon will die during configuring service object
Condition:
1. Create a virtual server rule with service object MFCT_9000 which uses tcp and 9000
for port.
2. Change MFCT_9000 as MCFT_9001.
3. Change its port from 9000 to 9001.
4. ZySH daemon will crash.
message.
16/142