ZyXEL Communications ZyWALL 1050 Release Note page 102

www.zyxel.com
16. [BUG FIX] 061115853
Symptom:
Packets could send out through wrong way
Condition:
1. Setup 3 WAN interfaces.Ethernet.PPPoE.PPTP.on 3 ports
WAN1 Zone=Ethernet ge2.port2.
WAN2 Zone=PPPoE ppp0.port3.
WAN3 Zone=PPTP ppp1.port4.
LAN Zone=Ethernet ge1.port1.
2. WAN_TRUNK=WAN1.WAN2.WAN3
3. Edit WAN_TRUNK rule
- Load Balancing Algorithm=Spillover
- Member=ge2.200..ppp0.100..ppp1.50.
- ge2 mode=Active, ppp0 mode=Active, ppp1=Passive
4. Edit ppp0 enable Ping Check, Ping this address=1.1.1.1
5. PC use Tfgen utilization set 300K to send out packet, it'll go through
ge2
6. Create another Tfgen utilization set 10K to send out packet, the packet
should go through ge2, but they go through ppp0
17. [BUG FIX] 061128602
Symptom:
GUI Help page issue
Condition:
1. By default, use GUI login into device.
2. Open the Help page.
3. The Help link is not correct, you select "File Manager", but it show "Registration".
102/142