ZyXEL Communications ZyWALL 1050 Release Note page 46

www.zyxel.com
18. [BUG FIX] SPR ID: 070829899
Symptom:
SIP (P2301R) can't connect correctly with the remote P2301R behind the ZW1050
Condition:
SIP_A(P2301R)---USG300---[WAN]---ZW1050---SIP_B(P2301R)
1.When the SIP_B(P2301R) connect directly to WAN , SIP_A and SIP_B can call each
other normally.
2. When the SIP_N (P2301R) connect to ZW1050 LAN side (means behind the ZW1050),
SIP_A and SIP_B can call each other but the voice can NOT PASS.
19. [BUG FIX] SPR ID: 070830945
Symptom:
Memory leak when doing IxVPN stress test.
Condition:
1. Enable AV, IDP, App patrol, ADP, CF
2. Do 1000 VPN tunnels stress test by IxVPN
3. Memory leak happens
20. [BUG FIX] SPR ID: 070903075
Symptom:
If you create a VPN connection with the "Wizard", the ZW1050 puts the "Secure Gateway
Address" in the "Local ID" content field.
Condition:
If you create a VPN connection with the "Wizard", the ZW1050 puts the "Secure Gateway
Address" in the "Local ID" content field.
21. [BUG FIX] SPR ID: 070906285
Symptom:
PPPoE messaging incorrect
Condition:
I am using a W2003 with RASPPPOE as BAS and had no problems with any ZW or
Prestige establishing a PPPoE connection. With the ZW1050 2.00XLC0 it does not work.
It seems that the W2003 is asking for EAP for authentication method in LCP and the
ZW1050 accept this, which is wrong (line 13 in Wireshark). ZW must reject and should ask
for C023 or C223 (PAP/CHAP) instead. Some other ZW PPP payload errors are shown, too.
22. [BUG FIX] SPR ID: 070914802
Symptom:
SSL VPN is dead in the following circumstance.
Condition:
1. I changed the extension pool to a single, unused local IP and SSL works fine this way
using the USG300 at home when connecting from work. No problem!
2. If I do the same on the Z1050 and try to connect from home via SSL VPN, the network
46/142