ZyXEL Communications ZyWALL 1050 Release Note page 114

www.zyxel.com
Symptom:
NTP update failed.
Condition:
Apply default configuration.
1. Use NTP to update system date.
Go to System->Date/Time
2. Enable "Get from Time Server" and click "Synchronize Now".
3. Sometimes update process failed but there is no error displaying on GUI.
4. In Log, we can see that there is a log record "NTP update has failed."
18. [BUG FIX] 060720269
Symptom:
Install the same certificate into EMS and M110B, but the "Subject Name" of it is
NOT the same.
Condition:
1. It happens when certificate is signed by CA.
2. One question: subject name in m70b is "CN=...." but in m110b is "...,CN=...",
and z1050 is also the same with M110b.
19. [BUG FIX] 060718042
Symptom:
ping check display counter incorrectly
Condition:
Router(config)# show ping-check status
Interface Status Fail Count
===========================================================
vlan0 Ok -9877
fail count should not be negative.
20. [BUG FIX] 060718041
Symptom:
While configuring in-use aaa object, the reference count could be reset to 0.
Condition:
1. By default configuration, the default aaa object is used by http service.
2. Configure default aaa object and show it again.
3. Since it is still used by http, the reference count should remain 1 but actually it
has been reset to 0.
21. [BUG FIX] 060714823
Symptom:
Virtual server rules may not be deleted correctly and rename address object would
cause virtual server rule applying failure
Condition:
1. Use the following script to reproduce the problem
address-object SERVER_WAN_IP 61.1.1.1
ip virtual-server test interface ge2 original-ip SERVER_WAN_IP map-to
192.168.4.2 map-type any
address-object SERVER_WAN_IP 61.1.1.2
ip virtual-server test interface ge2 original-ip 61.1.1.1 map-to 192.168.4.2 map-
type port protocol tcp original-port 80 mapped-port 80
114/142