Advertisement
Click
to add the camera directly.
Option 5: Add From the Preview Window
Note: This option is not applicable to NVRs with PoE ports. Some NVRs have PoE ports and non- PoE
ports, and some have PoE ports only. All these NVRs do not support this option.
1. In the preview page, click
2. Select the desired IP Cameras and then click OK
Option 6: Connect via Cable
1. Connect an IP Cameras to a PoE port or a switching port of the NVR with a network cable.
The connected
camera will be added to the NVR automatically.
2. Check the camera status under Menu > Camera > Camera > Camera.
Note:
•
This option is only applicable to NVRs with PoE ports, and the added camera cannot be deleted.
• If you want to add an IP Cameras that is not connected to the NVR's with a network cable,
change Plug- and- Play to Manual, and complete other parameters.
•
For NVR with PoE ports only,
or above the rated power of the connected
Option 7: Add From Another Network
Use this option when the NVR and the IP Cameras are connected to different router. Make
sure the NVR can access the camera via the camera's public IP address and mapped port
number.
Note: First you need to enable port mapping under Setup > Port > Port Mapping on the IP
Cameras' s Web
interface.
Option 8: Use Custom Protocol
Note:
•
Use this option when the IP Cameras supports the standard RTSP.
• Only live and recorded video streams are available from the camera added in this way. Configuration
operations are not supported.
1. Go to Menu > Camera > Camera > Camera.
2. Click Custom Add. Select Custom from the Protocol drop-down list.
in a window to go to the Add IP Cameras page.
appears under Status if the power output from a PoE port is below
24
UNIGUARD 4 & 8 HDD Series
,
Advertisement
