Advertisement
UNIGUARD 4 & 8 HDD Series
4.7.6
Alert
Configure alert actions for device abnormal events. The NVR reports an alarm when an event
occurs.
1. Go to Menu > Alarm > Alert.
2. Select an alert type from the drop-down list.
• IP Conflict : IP Cameras use the same IP address on the network
• Network Disconnected : An IP Cameras is offline.
• Disk Offline: No disk or a disk is not properly connected.
• High CPU Temperature: The CPU temperature of the NVR is too high.
• High Motherboard Temperature: The motherboard temperature of the NVR is too high.
• Disk Abnormal : A disk is in position but cannot work normally.
• Illegal Access: Incorrect username/password.
• Hard Disk Space Low: The disk space is about to use up.
• Hard Disk Full: The disk space has been used up.
• Array Damaged : The number of lost physical disks in an RAID exceeds the limit.
• Array Degraded : Some physical disks are lost in an RAID but the number of the lost disks is still
below the limit.
• Recording/Snapshot Abnormal : Videos/snapshots cannot be stored normally because the disk
is offline or abnormal.
3. Set the alert actions, including buzzer, sending email, and pop-up window.
4. Set the alarm output chan nel(s). You may select All, or select specified alarm output
channel(s).
5. Click Apply.
6. Repeat the above operations to configure alert actions for other events.
160
Advertisement
