Advertisement
7. Remote Access to the NVR
7.1 Preparation
Check the following before you begin:
• Access will be authenticated during login, and operation permissions will be required.
• The NVR is operating properly and has a network connection to the PC.
• A Web browser is installed on the PC. Chrome 60 or later is recommended. Firefox 60 or
later, Microsoft
Internet Explorer 10.0 or later, Edge 79 or later are also supported.
• The PC uses an operating system of Windows 7 or later.
• A 32-bit or 64-bit Web browser is required if you are using a 64-bit operating system.
Note:
•
The parameters that are grayed out on the Web interface cannot be edited. The parameters and values
displayed may vary with NVR model.
• The figures below are for illustration purpose only and may vary with NVR
7.2 Login
Follow these steps to log in to the Web interface (take IE10 browser as an example).
1. Open a Web browser on your PC, enter the IP address of the NVR in the address bar
(192.168.1.30 by default), and then press Enter.
2. Install the plug-in.
•
You need to install the plug-in as prompted at your first login, which is mainly used for
processing media streams. Close all the Web browsers when the installation starts. Follow
the on-screen instructions to complete the installation and then open the browser again to
log in.
•
You may also find the plug-in manually by entering HTTP://IP address/ActiveX/Setup.exe
in the address bar, and press Enter.
3. In the login page, enter the default username and password (admin/123456) and then
click Login.
UNIGUARD 4 & 8 HDD Series
187
Chapter
7
Advertisement
