Enabling/Disabling Http - Xerox WorkCentre 4118 System Administration Manual

Enabling/Disabling HTTP

This procedure is used to enable or disable Hypertext Transfer Protocol (HTTP) on the
WorkCentre 4118.
To enable HTTP, at the WorkCentre 4118, perform these steps:
Ensure the basic TCP/IP settings have been made (see "Basic TCP/IP Settings" on page
1
2-5).
Press the [Machine Status] button.
2
3
Press
Admin Tools displays and press
[Enter].
If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
4
Press
Setup displays and press [Enter].
5
Press
Network displays and press
[Enter].
Page 6-8
or until System
or until Network
or until Configure
System Admin Tools
[Passcode Protect]
System Admin Tools
[Network Setup]
Network Setup
[Config. Network]
Xerox WorkCentre 4118 System Administration Guide