Table of Contents
Advertisement
8 . 3 B o a r d I n s t a l l a t i o n
The CP6005(X)-SA is designed for use either as a system board or as an autonomous CPU board in a pe-
ripheral slot.
When installed in the system slot, the CP6005(X)-SA provides all required functions for supporting the
hot swapping of peripheral boards which are capable of being hot swapped.
When installed in a peripheral slot, the CP6005(X)-SA operates autonomously, meaning that it only
draws power from the backplane.
8.3.1
Hot Swap Inser tion
Prior to following the steps below, ensure that the safety requirements are met.
To insert the CP6005(X)-SA in a running system proceed as follows:
1.
Ensure that the board ejection handles are open.
2.
Insert the board into the slot designated until it makes contact with the backplane connec-
tors.
3.
Using the ejector handles, engage the board with the backplane. When the ejector handles
are closed, the board is engaged.
4.
The blue HS LED turns on and then off indicating that the CP6005(X)-SA is operating.
5.
Fasten the front panel retaining screws.
6.
Connect all external interfacing cables to the board as required.
8.3.2 Hot Swap Removal
Prior to following the steps below, ensure that the safety requirements are met. When removing a
board from the system, particular attention must be paid to the components that may be hot, such as
heat sink, etc.
To remove the CP6005(X)-SA from a running system proceed as follows:
1.
Unlock the board ejection handles by pressing their release buttons.
The blue HS LED starts blinking indicating that the shutdown process has begun.
2.
After approximately 1 to 15 seconds, the HS LED turns on steady indicating that the
CP6005(X)-SA may be removed from the system.
3.
Disconnect any interfacing cables that may be connected to the board.
4.
Unscrew the front panel retaining screws.
5.
Using the ejector handles, disengage the board from the backplane and remove it from the
system.
www.kontron.com
User Guide
CP6005(X)-SA
67
Advertisement
Table of Contents
