Table of Contents
Advertisement
Introduction
Table 1-2:
CP6002 Main Specifications (Continued)
FEATURES
Hot Swap Compatible
Gigabit Ethernet
USB
Serial
PMC
XMC
Keyboard and Mouse
Page 1 - 14
The CP6002 supports System Master hot swap functionality and application-
dependent hot swap functionality when used in a peripheral slot.
When used as a System Master, the CP6002 supports individual clocks for
each slot and the ENUM signal handling is in compliance with the PICMG 2.1
Hot Swap Specification.
Up to four 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces
based on up to four Intel® 82574L Ethernet PCI Express bus controllers:
Up to two RJ-45 connectors on the front panel
•
Two ports on the rear I/O (PICMG 2.16)
•
Automatic mode recognition (Auto-Negotiation)
•
Automatic cabling configuration recognition (Auto-MDI/X)
•
Six USB ports supporting UHCI and EHCI:
Two type A USB 2.0 connectors on the front panel
•
Four USB 2.0 ports on the rear I/O interface
•
Two 16C550-compatible UARTs (RS-232/RS-422 signaling):
One RS-232 port on the front panel and routed to rear I/O, COM1
•
One RS-422 port on the rear I/O, COM2
•
Up to two PMC slots:
Onboard mezzanine connectors for standard PMC modules:
•
Four connectors for PMC / XMC slot A (Jn1-Jn4)
•
Three connectors for PMC / XMC slot B (Jn1-Jn3), optional
•
Up to 64-bit / 66 MHz PCI or up to 64-bit / 100 MHz PCI-X interface with
•
dedicated PCIe-to-PCI-X bridge
Only 3.3V PCI signaling voltage
•
Rear I/O supported through the CompactPCI connector J4 (slot A)
•
Supported voltages: 3.3 V, 5 V, +12 V, and -12 V
•
Up to two XMC slots:
One onboard XMC connector (P15) for PMC / XMC Slot A
•
One onboard XMC connector (P15) for PMC / XMC Slot B, optional
•
Up to x8 lanes PCI Express per XMC slot
•
Rear I/O supported through the PMC connector (Jn4) to the
•
CompactPCI connector J4 (slot A)
Keyboard and mouse are supported:
USB support
•
SPECIFICATIONS
ID 1036-6431, Rev. 2.0
CP6002
Advertisement
Table of Contents
