Table of Contents
Advertisement
2.2. Inserting a Node Module
ESD Sensitive Device!
Take all necessary ESD protection measures.
1.
Holding the handle, insert a node module.
2.
Push it in until the safety lock locks in place. The ID LED becomes steady blue and then turns off during BMC
initialization.
3.
After BMC initialization, the power LED of the processor node module becomes steady green: the processor
node module is powered on and ready to use.
2.3. System Behavior upon Hot Swap
The system is electrically designed to support a surprise extraction. However, this type of
extraction is not recommended and could affect system performance and functionalities.
When a hot swap procedure is performed on node MSP802x, the following systems and functionalities could be
affected:
All nodes:
Node-dedicated applications could be affected.
www.kontron.com
MSP8020 Series User Guide Rev. 1.1
// 20
Advertisement
Table of Contents
