Table of Contents
Advertisement
_____________________________________________
E _m __ e_ r-= g =- e _n_ c -==
y "-s_ i_ t _ u _ a _t_i_ o _n _ s _ __._
Rear hook
up
- Align the vehicle with t he cente rline of the car carrier
ramp.
- Attac h the winch hook to the rear towline eye previously
inst alled.
(I]
Tips
Check carefully to make sure the hook-up is secure before moving the
car up the flatbed truck ramp . •
Lifting
vehicle
Lifting
with
workshop
hoist
and
with
floor
jack
The vehicle may only be lift ed at the lifting points illus-
trated.
Fig. 17 8 Rear liftin g
point (right side)
Vehicle OP-eration
Fig. 179 Front lift ing
point (right side)
- Read and heed WARNING :::> & .
- Locate lifting points :::> fig. 178 :::> fig . 179 .
- Adjust lifting arms of wor kshop hoist or floor jac k to
match vehicle liftin g points.
- Inse rt a rubber pad between t he floor jac k/wo rkshop hoist
and the lift ing points.
If you must lift your vehicle with a floo r jack to wo rk underneath ,
be sure the vehicle is safely supported on stand s intended for thi s
purpose.
Front
lifting
po int
The lifting point is located on the floor pan reinforcement about at
the same level as the jack mounting point=:> fig. 179 .
Do not lift the
vehicle at the vertical sill reinfo rcement.
Rear lifting
po int
The lifting point is located on the vertical reinforcement of the lower
sill for the onboard jack=:> fig. 178 .
Lifting
with
vehicle
jack
Refer to =:>
page
254 .
Vehicle care
Do-it-yourself service
iTechnical data
Advertisement
Table of Contents
