Table of Contents
Advertisement
ffl..__
H _ o_ m _ e _L _ in _k _ ® _______________________________________________
_
Programming
the
Homelink
® transmitter
The transmitter is programmed in two phases. For rolling
code transmitters, a third phase is also necessary.
Fig. 91 Overhead
console: HomeUnk ®
keypad
Fig. 92 Front bumper,
driver side: locat ion of
trans mitter unit
Phas e 1 : progr a mming
the overhe a d k e yp a d
1. Make sure your vehicle is within operating range of the
remote controlled garage door opener.
2. Set the parking brake =:>
&
in "General information ".
3 . Turn the ignition on . Do not start the engine!
4 . Press and hold the two outside Home Link® buttons
G)
and
@ for approximately 20 seconds until indicator light @
=>
page 102,
fig. 91 begins to flash. Then release both
buttons . Do not hold the buttons for longer than 30
seconds .
This procedure only needs to be performed
on ce.
It erases
the factory-set default codes and does not have to be
repeated to program additional remote controls .
5. Press and hold the Homel ink® button
G),
@ or @ until
the indicator light @ starts flashing
slowly .
Release the
button.
- The system will remain in programming mode for 5
minutes . Co to the front of the vehicle and proceed with
phase
2 .
Phase
2:
p rogramming
the bumper
mounted
t ransmit
ter
6. Hold the
original remote control
at a distance between 0-
6 in. (0- 15 cm) from the bumper below the appropriate
headlight for your vehicle =:> fig . 92 (use the shortest
distance possible).
7 . Aim the remote control just below the
driver side
head-
light .
8 . Press and hold the activation button on the remote
control.
- May be different in Canada . If so, press and re-press
(cycle) the activation button on your remote control every
two seconds .
_,,
Advertisement
Table of Contents
