Table of Contents
Advertisement
___________________________________________________
H _ o _m __ e_ L _i_ n_k _® _ R _
__.11
9 . The emergency flashers will flash
three t ime s
(after about
15-60 seconds) when the programming
is successful.
Release the button on the remote control.
- To program more devices, repeat steps 4 to 9.
10. Press and hold the trained Homelink ® button and
observe the indicator light @ ~
page
102, fig . 91.
- If the indicator light is solid/continuous,
programming is
complete and your device should activate when you press
and release the trained Homelink ® button.
- If the indicator light blinks rapidly for 2 seconds and is
then a solid/continuous
light, proceed with phase 3 to
program a rolling code device.
Ph a se 3: ro lling
cod e programming
- A second person on a ladder who can safely reach the
garage door opener motor is recommended.
11 . Locate the "learn" button on the garage door opener
motor (refer to the operating instructions for the opener,
as t he location of this button may vary by manufacturer) .
12. Press and release the learn button on the garage door
opener motor.
- Note:
once the button is pressed, there are
30 seconds
in
which to initiate the next step.
13. On the Homelink® keypad inside the vehicle, firmly press
and hold the Homelink ® button previously programmed
in phases 1 and 2 for two seconds and release. Repeat this
sequence
twi ce.
Cont rols an d equ ip-
men t
Vehicle OP-eration
- Some vehicles may require the press/hold/release
sequence up to three times to complete the training
process.
- Homelink ® should now activate your rolling code
equipped device.
If the 5 minute time limit is exceeded, the e me rge ncy flas hers will
fla sh one t ime to indicate that the process has been terminated. In
this case, repeat steps 4 th rough 9.
If
the emergency flashers do not flash
three
times (after about 15 -
60 seconds), programming was not successful. In this case, repeat
steps 4 through 9.
Remote control units for garage door openers in Canada are set to
stop transmitt ing radio frequency signals after two seconds. This
time may not be sufficient for the Home link ® system to learn the
rad io frequency signal. Perform all other steps as described above. •
Operating
the
Homelink
® transmitter
The Homelink ® transmitter works in the same manner as
the original hand held remote control that came with the
system.
0
0
-
4
Vehicle care
Fig. 93 Overhead
console: Homeli nk®
keypad
...
Do-it-yourselt service
iTechnical data
Advertisement
Table of Contents
