Table of Contents
Advertisement
Wha t do I do now ?
-
____________
____;__...;____;____.:....::......;;______J
Fig. 1 57 Connec tor
f or the Tire Mobility
System
Assembling
Tire Mobility
System
Open the lid @ of the electric air pump=:> page 250,
fig . 156 .
- Pull the plug © and the pressure hose © with the gauge
out of the housing .
- Screw the pressure hose © of the electric air pump onto
the flange © of the sealant bottle
(D.
- Push the sealant bottle with the flange down into the
recess ® on the lid of the electric air pump.
- Remove the dust cap from the valve of the defect ive tire.
- Screw the hose @ onto the valve
0
=:> fig . 157.
- Insert the plug © =:> page 250, fig. 156 into the socket
for the cigarette lighter .
Inflating
tir e
- Move the switch @ =:> fig . 157 on the electric ai r pump
5
l
to position I. After 5 minutes, tire pressure must have
reached at Least 1.8 bar.
SJ The elect ric air pu mp should neve r run for lon ger than 8 minutes .
Vehicle OP-eration
- Switch the electric air pump off - switch in position 0. If
the required tire pressure of at Least 1.8 bar has not been
reached, follow the instructions in the section Re-inflating
tire.
Re - inflating
tire
- Remove the hose from the valve and pull the plug out of
the socket .
- Drive the vehicle slowly 10 meters backward or forward .
This helps to distr ibute the sealant better.
- Remove the empty inflation bottle and screw the hose ©
=:> page 250, fig . 156 from the electric pump directly onto
the valve .
- Insert the plug © =:> page 250, fig . 156 into the socket
for the cigarette lighter.
- Move the switch @ =:> fig . 157 on the electric air pump
5 )
to position I. After 5 minutes, tire pressure must have
reached at least 1.8 bar .
- Switch the electric air pump off - switch in position 0. If
the required tire pressur e of at least 1.8 bar has not been
reached , it is not possible to make a repair with the tire
sealant . Seek professional assistance.
Disassembling
Tire Mobility
System
- Remove the hose from the valve and pull the plug out of
the socket .
- Screw the dust cap onto the valve .
- Place the empty sealant bottle back in the or iginal pack-
aging and clip it in place under the floor so that no tire
sealant can run out into the vehicle .
.,
Vehicle care
Do-it-yourself service
iTechnical data
Advertisement
Table of Contents
