Table of Contents
Advertisement
IIIIL-__;
H ..:..:
o:..:;
m ..:..:..;
e ::.. L : :.:.:
i n ..:.:..:
k:... ® ________________________________________________
_
- Press the appropriate
programmed
button
G),
@ or @
to activate the desired remote control function::::>
&
in
"General information"
on
page 101. •
Reprogramming
a single
button
A Homelink ® button can be reprogrammed individually
without affecting the other button allocations.
Programming
the overhead
keypad
- Press the appropriate
Homelink ® button until the indi-
cator light begins flashing slowly.
Programming
the bumper
mounted
transmit
ter
1. Hold the
original remote control
at a distance between O-
S in. (0-13 cm) from the bumper below the appropriate
headlight for your vehicle (use the shortest distance
possible).
2. Aim the remote control just below the driver side head-
light.
3. Press and hold the activation button on the remote
control.
4. The emergency flashers will flash three times (after about
15-60 seconds) when the programming
is successful.
Now release the button on the remote control.
- If the device utilizes a rolling code, please follow phase 3
of =>
page 102,
"Programming
the Homelink® trans-
mitter" for rolling code programming .
This procedure will cause the existing programming on the
Homelink ® button to be erased! •
Erasing
the
programming
of the
Homelink
® transmitter
When you erase the programming, the programming on
all three of the transmitter channels with be lost!
- Perform steps 1 to 4 as described on ::::>
page 102,
"Phase
1: programming
the overhead keypad".
When completed, the Homelink ® system will be in the programming
mode and is then ready to learn the codes for remote controlled
devices .
W
Tips
•
Programmed
buttons cannot be erased individually .
•
For security reasons you are advised to erase the programming
of
the Homelink ® system before you sell your vehicle . •
Advertisement
Table of Contents
