Table of Contents
Advertisement
Service stuff qualification requirements for tractor "BELARUS-3522.5" operation:
- only qualified personnel that is aware of safety arrangement and precautions mat-
ters, having license documents of due form, determined by the legislation for tractor driving
and having got admission to operate certain tractor, is allowed.
- if tractor owner (or any person liable for tractor operation) does not operates tractor
himself, he must ensure that before starting operations all persons related to the tractor
have been duly instructed on safety operation requirements and on correct coupling of im-
plements with the tractor, and have studied the operation manuals for the tractor and the
engine enclosed.
ATTENTION: OWNERS AND OFFICIALS OR OTHER PERSONS MUST NOT AL-
LOW THE TRACTOR FOR ROAD TRAFFIC AND COUPLING WITH IMPLEMENTS, OR
ADMIT OPERATORS FOR DRIVING THE TRACTOR IN CONTRAVENTION OF CUR-
RENT TRAFFIC REGULATIONS AND THE PRESENT OPERATION MANUAL!
ATTENTION: BEFORE STARTING THE TRACTOR IN STRUCTURE OF MTU EN-
SURE THAT THERE IS NO PEOPLE IN CLOSE VICINITY TO THE TRACTOR INCLUDING
THE AREA BETWEEN THE TRACTOR AND IMPLEMENTS OR TRAILERS (SEMITRAIL-
ERS) COUPLED!
5.2 Types of implements coupled with tractor "BELARUS-3522.5"
According to the type of coupling with tractors «BELARUS-3522.5» the implements
are divided into the following types:
- mounted implement is fixed in three points to the upper and lower draft arms of LL.
The tractor can carry weight of an implement in full. Implement structural components at
carry is not in touch with ground contact area. While changing the implement position from
operating to transport the point in which the implement is connected to the tractor is forcedly
displaced to the new point along the full vertical extent;
- semimounted implement is fixed in three points to the upper and lower draft arms of
LL or just in two points to the upper and lower draft arms of LL only. The tractor can carry
weight of an implement in part and mostly by its traveling wheels (usually by one or two wheels).
While changing the implement position from operating to transport, the point in which the im-
plement is connected to the tractor is forcedly displaced to the new point along the full vertical
extent. Two-point articulated linkage is effected by way of connection of suspension axis link pin to
the lower draft arms hinges of LL (upper draft arm is not used). It is also possible to use a cross
arm from the tractor or implement kit.
- semitrailed implement is usually fixed in one point by means of tractor drawbar clevis
to the DH. It is also possible to use a two-point connection with lift linkage (upper draft arm is not
used). The tractor can carry weight of an implement in part and mostly by its traveling wheels
(usually not less than by two). While changing the implement position from operating to trans-
port, position of the point in which the implement is connected to the tractor remains un-
changed. Semitrailed implements include various vehicles for general and special purposes: gen-
eral purpose semitrailers, tank semitrailers and dampers, and special purpose semitrailed vehicles
for mechanizing of technological process in the agricultural sector.
- trailed implement is usually fixed in one point by means of tractor drawbar clevis to
the DH. It is also possible to use a two-point connection with lift linkage (upper draft arm is not
used). The chassis can carry weight of an implement in full, hitch mechanism (DH or LL) is
loaded only by weight of implement connector. While changing the implement position from
operating to transport, position of the point in which the implement is connected to the tractor
remains unchanged. Semitrailed implements include various vehicles for general and special pur-
poses: general purpose semitrailers, tank semitrailers, and dampers, and special purpose semi-
trailed vehicles for mechanizing of technological process in the agricultural sector.
240
https://tractormanualz.com/
3522.5-0000010 OM
Advertisement
Table of Contents
Troubleshooting
