Table of Contents
Advertisement
Inertial Measurement Unit IMUF99*B16
Introduction
1.4
Intended Use
The Inertial Measurement Unit IMUF99*B16, with the F99-Fusion technology, is optimized to
provide gyroscopic stabilized inclination and acceleration data as well as rotation rate data.
Read through this manual carefully. Familiarize yourself with the device before installing,
mounting, or operating.
Always operate the device as described in these instructions to ensure that the device and con-
nected systems function correctly. The protection of operating personnel and the plant is guar-
anteed only if the device is operated in accordance with its intended use.
Note
Correct Usage in Applications
The sensor can be used in complex structures and applications, such as implementations in
bus networks and machines where specific control routines are used on customer side.
It is recommended to process measured data according to the rules of measurement
engineering and control theory. It is further recommended to derive adequate measures for the
specific application.
1.5
General Safety Notes
Responsibility for planning, assembly, commissioning, operation, maintenance,
and dismounting lies with the plant operator.
Installation and commissioning of all devices may be performed only by trained and qualified
personnel.
The device is only approved for appropriate and intended use. Ignoring these instructions
will void any warranty and absolve the manufacturer from any liability.
If serious faults occur, stop using the device. Secure the device against inadvertent operation.
In the event of repairs, return the device to your local Pepperl+Fuchs representative or sales
office.
Note
Disposal
Electronic waste is dangerous. When disposing of the equipment, observe the current statutory
requirements in the relevant country of use and local regulations.
1.6
Declaration of Conformity
This product was developed and manufactured in line with the applicable European standards
and directives.
Note
A declaration of conformity can be requested from the manufacturer.
The product manufacturer, Pepperl+Fuchs Group, 68307 Mannheim, Germany, has a certified
quality assurance system that conforms to ISO 9001.
ISO9001
8
Advertisement
Table of Contents
