Trunk Group Operation - Mitel SX-5 Manual

SECTION MllL9103 -098 -105 -NA
Trunk Group Operation
Description
Selection of this feature allows an extension user access to either trunk by dialing the
trunk group access code (9). If trunk 1 is busy, the SX-5 will automatically access
trunk
2.
If both trunks are busy, busy tone is returned. Refer to Discriminating Ringing
and Direct Trunk Select
Conditions
On loading default data SW1 must be set to OPEN to enable Trunk Group Operation.
The trunk access code is 9.
When one trunk is busy, the SX-5 automaticaily accesses the other trunk.
If both trunks are busy
-
busy tone is returned.
Feature Selection
To Enable Trunk Group Operation:
Set SW2 to OPEN.
Lift
the
Control Extension handset
-
dial tone is returned.
Dial 4232
-
acknowledge tone is returned.
Set SW2 to
CLOSED.
NOTE:
Acknowledge tone may be one of two tones; they are:
One beep none 1). indicates that the new feature access code has been
accepted.
Two beeps (Tone
a,
indicates that the feature was already selected.
The relevant tone is repeated three times. Reorder tone will be received
when the dialed code is invalid.
Operation
To Initiate a call in Trunk Group Operation:
Lift extension handset
-
dial tone is returned
Dial 9
-
wait for dial tone
Dial the required directory number.
Page
60