Rotary Dial Pulse-To-Digit Conversion - Mitel SX-5 Manual

SECTION MITL9103-098-105-NA
Rotary Dial
Pulse-to-Digit
Conversion
Description
In some geographical locations telephone sets do not pulse on a 1 : 1 ratio. To
accommodate these telephones sets and their associated Central Offices, the SX-5
allows the selection of four different digit translation plans as shown in Table 5
below. This allows the SX-5 to be used in any country irrespective of that country's
digit translation. Refer to Selectable Tone Plans and Selectable Ringing Frequency.
Table 5
Rotary Dial Pulse-to-Digit Translation PIans
Number of
Pulses
Translation
Code
1
2
3
4
Conditions
Digit Dialed
1 2 3 4 5 6 7 8 9 0
1 2 3 4 5 6 7 8 9 10
2 3 4 5 6 7 8 9 1 0
1
9
8 7 6 5 4 3 2 1 10
1 0 9 8 7 6 5 4 3 2
1
None
Feature Selection
To select the required Rotary Dial Pulse-to-Digit Translation Plans:
Set SWZ to OPEN.
Lift Control Extension handset
-
dial tone is retuned.
Dial 440A where A is the desired translation code as defined in Table 5.
Replace handset
-
the selected Translation Plan is enabled.
Set SW2 to CLOSED.
Operation
Autamatic
Page
46