System Selection - Mitel SX-5 Manual

System Selection
SECTION MITL9103-098-105-NA
Description
The SX-5 has two modes of operation: Direct Trunk Select and Trunk Group Operation.
In the Direct Trunk Select mode each trunk has its own access code and may only be
accessed by a n extension user dialing that code. In the Trunk Group Operation only one
code is necessary to access either trunk The mode of operation is selected by the
setting of Switch 1 (SW1) when the default data is loaded. Distinctive ringing for
Incoming Trunk identification is also enabled when the Direct Trunk Select mode is
selected. (Refer to Discriminating Ringing).
Conditions
The setting of switch
1
is only read at the time the default data is loaded. Switch 1
has no effect at any other time.
Feature Selection
To Enable Direct Trunk Select and Disable Trunk Group Operation
Set SW2 to OPEN.
Lift the Control Extension handset
-
dial tone is returned.
Dial 4231
-
acknowledge tone is returned.
Replace the handset
-
the SX-5 operates in the Direct Trunk Select mode.
Set SW2 to CLOSED.
To Disable Direct Trunk Select and Enable Trunk Group Operation.
Set SW2 to OPEN.
Lift the Control Extension handset
-
dial tone is returned.
Dial 4232
-
acknowledge tone is returned.
Replace the handset
-
the SX-5 operates in the Trunk Group Operation mode.
Set SW2 to CLOSED.
NOTE:
Acknowledge tone may be one of two tones; they are:
One beep (Tone 1). indicates that the new feature access code has been
accepted.
Two beeps (Tone 2). indicates that the feature was already selected.
The relevant tone is repeated three times. Reorder tone will be received
when the dialed code is invalid
Operation
Automatic
Page 53