Control Functions - Mitel SX-5 Manual

SECTION MITL9103-098 -105 -NA
Control Functions
Description
Control Functions are features which control the day-to-day operation of the SX-5,
such as switching the system in or out of Night Service. Control Functions may be
performed only from the Control Extension (EN 1) and consist of dialing a string of
digits to access the features. Table 2 lists the Control Functions and their access
codes. Control Functions may be accessed from the Control Extension at any time.
Control Function operation is NOT dependent on the setting of SW2.
Table 2
Control Functions
Conditions
Control Functions
Clear Functions
Day/Night Service
Music Selection, Background Music/Music
on Hold
Ring Group Settings
Pickup
Group
Settings
Speed Dial Number Setting
Control Functions may only be performed from the Control Extension.
All Control Function access codes begin with digit 3.
Only one Control or Programming Function may be performed at one time.
If incorrect digits are entered
-
reorder tone is retumed.
If correct digits are entered
-
one burst of tone is returned (acknowledge
tone
1).
If c m t digits are entered and the state of the system is not altered
-
two
bursts are returned (acknowledge tone 2).
For further information on Access Codes and individual Control Functions, refer
to individual feature descriptions in this practice.
Access Code
30
3
1
32
33
34
35
NOTE
Acknowledge tone may be one of two tones; they are:
One beep (Tone I), indicates that the new feature access code has been
accepted.
Two beeps (Tone 2). indicates that the feature was already selected.
The relevant tone is repeated three times. Reorder tone will be received
when the dialed code is invalid.
Feature Selection
None
Operation
Refer to individual Control Function feature description.
Page 18