Trunk Module Removallreplacement; Memory Module Removallreplacement - Mitel SX-5 Manual

SECTION MITL9103 -098 -350 -NA
Trunk Module RemovallReplacement Memory Module RemovallReplacement
6.05 There is one trunk module in an SX-5,
comprising two trunk circuits The module
is located in the top right-hand side of the main
board (refer to Fig 6- 1
I.
6.06 To remove a trunk module proceed as fol-
lows
Remove power from the system, but
maintain the ground connection
Gain access to the trunk module (refer to
Para 3.04).
Remove the three screws which secure the
module to the main board Take w e not to
lose the accompanying washers
Working in even stages from the edges of
the module, carefully separate the module
from the main board
6.08 There is one memory module in an SX-5
which is located on the left-hand side of
the main board (refer to F i g 6-
11.
6.09 To remove a memory module proceed
as
follows:
Remove power from the system, but
maintain the ground connection
Put on wrist strap.
Gain access to the memory module (refer
to Para 3.04).
Remove the three screws which secure the
module to the main board Take care not to
lose the accompanying washers
Working in even stages from the edges of
the module, carefully separate the module
from the main board
6.07 The replacement procedures for a trunk
6.10
The replacement procedures for a memory
module are the reversal of those for the
module are the reversal of those for the
removal. Great care must be exercised to ensure
removal. Great w e must be exercised to ensure
that the connecting pins are correctly seated
that
the connecting pins are correctly seated
Page
6