Discriminating Ringing - Mitel SX-5 Manual

D i s c r i m i n a t i n g Ringing
SECTION MITL9103 -098 -105-NA
Description
Selection of this option allows an extension user to distinguish between internal calls
and incoming trunk calls by distinctive ringing patterns. In addition, different ringing
patterns may also be assigned to each incoming trunk. allowing individual trunks to be
distinguished. Internal calls have a ringing pattern of 1 s on 3 s off. The ringing pattern
for incoming trunk calls is determined when the default data is loaded. dependent on
which mode of operation is selected, i . e. Direct Trunk Select or Trunk Group Operation.
However the ringing pattern for incoming trunk calls may be changed as detailed in
Feature Selection.
Conditions
On Initial Power-up:
In Trunk Group Operation mode, all incoming trunk calls have the same ringing
pattern, 400 ms on, 200 ms off, 400 ms on, 3 s off (i.e. two quick rings),
continuous until the call is answered.
In Direct Trunk Select mode, there is discriminating ringing between Trunk 1
and Trunk 2 .
For Trunk 1 the ringing pattern is 400 ms on. 3.6 s off, (i.e. one
quick ring), continuous until the call is answered. For Trunk 2 the ringing pattern
is 400 ms on. 200 ms off, 400 ms on, 3 s off (i . e. two quick rings), continuous
until the call is answered
Feature Selection
To Enable Identical Ringing for Both Trunks:
Set SW2 to OPEN.
Lift the Control Extension handset
-
dial tone is returned.
Dial 4242
-
acknowledge tone is returned
Replace the handset
-
Trunks 1 and 2 have the same ringing pattern.
Set SW2 to CLOSED.
To Enable Discriminating Ringing for Each Trunk:
Set SW2 to OPEN.
Lift the Control Extension handset
-
dial tone is returned.
Dial 4241
-
acknowledge tone is returned.
Replace the handset
-
Trunks 1 and 2 have different ringing patterns.
Set SW2 to CLOSED.
NOTE:
Acknowledge tone may be one of two tones; they are:
One beep none
1).
indicates that the new feature access code has been
accepted.
Two beeps (Tone 2), indicates that the feature was already selected
The relevant tone is repeated three times. Reorder tone will be received
when the dialed code is invalid.
Operation
None
Page 27