Tone Signaling; Trunk Group Busy Indication; Additional Attendant Functions - Mitel SX-200 Manual

Tone Signaling

Trunk Group Busy indication

1 2 3 4 5 6 7 6 9
TRK GRP>
S T A T U S > 0 0
q Fl >EXIT
q
q
Additional
The display will return to the format it had before leaving the CDE or
Maintenance levels.
3.34 This feature allows the Attendant to send DTMF tones during a
call. COS Option 119 - Attendant Tone Signaling must be en-
abled. When enabled, this option results in the TONES ON softkey
being displayed whenever the Attendant is talking on an internal or
external call. Pressing TONES ON enables the tones generated by the
dial keypad. Pressing TONES ON also causes the softkey
toggle to TONES OFF. Tones dialed using this feature are ignored by
the PABX, and are transmitted out onto the line or trunk. Pressing
TONES OFF disables Tone Signaling.
3.35 This feature is used to display the status of Trunk Groups.
Trunk Group Status may be displayed when the console is idle,
or when a call is in progress. If used when the console is idle, the
display is updated every 5 seconds. To use the feature press the
TRUNK STAT fixed key. The first 19 Trunk Groups will be displayed.
Press the MORE softkey
once more to see the last 11 Trunk Groups. After the last 11 groups
are displayed, pressing MORE will re-display the first 19 groups. The
solid block beneath the Trunk Group number indicates that group is
busy. To exit the feature, press the EXIT softkey.
q
F3>
q
jF7>
Figure 3-26 Trunk Group Busy indication
Attendant
3.36 Additional Attendant functions are accessed by the use of fixed
key and softkey
pressed to access the softkey
ance of the Attendant Console display after the fixed FUNCTION key
has been pressed.
F o r f u r t h e r i n f o r m a t i o n , r e f e r t o S e c t i o n
Maintenance
to see the next 20 Trunk Groups, and press it
0 1 2 3 4 5 6 7 6 9
10
q
q fg>
Functions
functions. The fixed FUNCTION key must be
functions. Figure 3-27 gives the appear-
Attendant Console
Terminal.
q
F5>
q
Description
label to
Page 19