Direct Outward Dialing - Mitel SX-5 Manual

SECTION
MITL9103-098-105-NA
D i r e c t O u t w a r d D i a l i n g
Description
This feature allows any extension within the SX-5 to access the public network by
dialing a single-digit Trunk Access Code. Trunks may be selected either individually
(Direct Trunk Select) or as a group (Trunk Group Selection). Refer to Direct Trunk Select
and Trunk Group Operation, in this practice.
Conditions
When Default Data is Loaded:
To operate in the Direct Trunk Select mode, SW1 must be set to OPEN.
To operate in the Trunk Group Operation mode. S W l must be set to CLOSED.
Feature Selection
To Enable Direct Trunk Select (i.e. Disable Trunk Group Operation):
Set SW2 to OPEN.
Lift the Control Extension handset
-
dial tone is returned
Dial 4231
-
acknowledge tone is returned
Set SW2 to CLOSED.
To Disable Direct Trunk Select (i.e. Enable Trunk Group Operation):
Set SW2 to OPEN.
Lift the Control Extension handset
-
dial tone is returned.
Dial 4232
-
acknowledge tone is returned.
Set SW2 to CLOSED.
NOTE
Acknowledge tone may be one of two tones; they are:
One beep Kone 1). indicates that the new feature access code has been
accepted.
Two beeps Kone 2). indicates that the feature was already selected
The relevant tone is repeated three times. Reorder tone w i l l be received
when the dialed code is invalid.
Operation
To Initiate a Trunk Call:
Lift the extension handset
-
dial tone is retumed.
Dial the required trunk access code
-
wait for dial tone
Dial the Directory Number (i.e. 555-1234)
NOTE:
The trunk access codes allocated by the default data are:
9. 8 when in the Direct Trunk Select mode.
9 when in the Trunk Group Operation mode.
Page 25