Wait For Dial Tone - Mitel SX-5 Manual

SECTION MITL9103 -098 -105 -NA
Wait
for Dial Tone
Description
This feature allows selection of the maximum period of time the system will wait to
receive dial tone from a trunk. Digits dialed before dial tone is received or before the
time-out period specified are not outpulsed by the system.
Feature Selection
To Specify the Wait for Dial Tone Period:
Set SW2 to OPEN.
Lift the control Extension handset
-
dial tone is returned.
Dial 43A5B where
A
=
1 if the wait for dial tone period is to be specified for trunk 1.
=
2 if the wait for dial tone period is to be specified for trunk
2
B
=
1 outpulse digits immediately i . e. no wait
=
2 wait a maximum of 5 s before outpulsing
=
3 wait a maximum of 1 min. before outpulsing
Set SW2 to CLOSED.
Operation
None
Page 63