Tone-To-Pulse Conversion - Mitel SX-5 Manual

SECT ION MITL9103 -098-105-NA
Tone-to-Pulse
Conversion
Description
This feature allows the SX-5 to automatically convert
M M F
signals from DTMF
equipment to dial pulse (rotary) signals where the
CO
or distant end of the outgoing
h n k is not equipped to accept DTMF signals.
Conditions
When the "disable outgoing audio until answer supervision" feature is selected there
are three methods to reestablish the audio; they are:
-
Dial
#
once the directory number has been dialed.
-
Answer supervision has been detected by the SX-5.
-
10 s after dialing the last digit, outgoing audio is automatically reenabled.
Feature Selection
To Specify Tone-to-Pulse Conversion:
Set SW2 to OPEN.
Lift the Control Extension handset
-
dial tone is returned.
Dial 43A6B where
A
=
1 if Tone-to-Pulse Conversion for trunk 1 is to be specified.
A
=
2
if Tone-to-Pulse Conversion for trunk 2 is to be specified
B
=
1 if conversion is not required.
B
=
2 if conversion is required.
B
=
3 if conversion is required and outgoing audio is to be disabled.
Set SW2 to CLOSED.
Page
57