Control Extension - Mitel SX-5 Manual

SECTION MITL9103 -098 -105 -NA
C o n t r o l E x t e n s i o n
Description
The extension connected to Equipment Number
1
(EN
1)
is known as the Control
Extension. This extension may be used as a conventional extension or to change
programming and control functions of the SX-5.
Conditions
Only the extension connected to Equipment Number
1
can be used as the Control
Extension.
All programming and control functions are performed from the Control Exten-
sion.
To access Programming. SW2 must be set to OPEN.
Control Functions may be accessed at any time, regardless of the position of
SW2.
Feature Selection
None
Operation
Set SW2 to OPEN if programming i s to be performed.
Lift the Control Extension handset
-
dial tone is returned.
Dial the required Programming or Control Function access code
-
acknowledge
tone is returned as each parameter is changed
Replace the handset
Set SW2 to CLOSED.
NOTE:
Acknowledge tone may be one of two tones; they are:
One beep none
1).
indicates that the new feature access code has been
accepted.
Two beeps none 2). indicates that the feature was already selected
The relevant tone is repeated three times. Reorder tone will be received
when the dialed code is invalid.
Page 17