Table of Contents
Advertisement
BASIC OPERATION
How to turn ON/OFF the power of
the transmitter
®
in operating system in the T32MZ-WC transmitter.
on/off.
When turning on the power of the transmitter
1. Place the throttle stick below 1/3 closed.
2. Turn on the power switch.
*After initialization of the transmitter is complete, the LED
monitor turns Purple.
*If your throttle stick is not at 1/3 closed or fully closed, a
warning will sound. If you move the throttle to 1/3 closed
or fully closed, the warning will stop and will become a
"Transmit ?" screen.
*If you push the button "NO", then the transmitter will not
emit radio waves.
*If you push the button "Yes", then the transmitter will emit
radio waves.
*If a battery is removed and it re-connects, please switch
on a power supply, after 3 seconds or more pass.
Start-up time;
Cold start;
If you turn on the transmitter more than four hours after you last
circuit of the transmitter.
Hot start;
If you turn on the transmitter less than four hours after you last
WARNING
Once you turn on the power, never shut off the power
switch until the power becomes stable (or until the first screen
shows up). If you turn off the power switch while the transmit-
ter is going through the initialization process, the data could be
damaged.
Note:
30
How to stop the transmitter
Once you turn off the power, never operate the power
switch until the power shutdown process is fully completed. If
you turn on the power switch again while the transmitter is still
in the process of power shutdown, the data could be damaged.
How to reset software
all the other functions for radio control operation remain
Quick start
HOME/EXIT
Screen OFF
Quick start
WARNING
While in screen off mode, it consumes about 4% of
the battery per hour. If you do not use the transmitter for
a long time, turn off the power.
Updates cannot be performed in screen off mode. To
update, turn off the power.
While holding down
the HOME / EXIT
power switch.
Advertisement
Table of Contents
