FUTABA 32MZ-WC Full Manual page 216

The " FLT.EXPERT "
" EXPERT MENU 3D " screen.
＜ Model Menu (Helicopter) ＞
216
FLT. Expert（Aileron/Elevator Gyro Expert Setting） FLT. Expert（Aileron/Elevator Gyro Expert Setting）
" FLT. EXPERT " screen from the
(1) HeadHld A / HeadHld E: Head hold aileron / elevator
This features is used to adjust the heading hold aspect of the gyro con-
trol. If the helicopter is not holding angle or cyclic control rates, increas-
ing the heading hold gain will improve holding the helicopter at a certain
angle and improve the cyclic rate consistency. If this is set too high you
could see an oscillation on that axis. Lowering the heading hold below
default would be used if the transmitter gain is reduced and a consistent
oscillation is still not fixed during flight.
Setting ranges: 0 ~ 200% Initial value: 80%
(2) StopTune A : Stop tune aileron
Cyclic stop tuning on the aileron axis. If the helicopter continues to coast
after an after an ail roll, lowering "StpTune A" will create a harder stop action
to remove the coasting. If the helicopter bounces on the aileron axis after
an aileron control input, increasing "StpTune A" will reduce this bounce.
Setting ranges: 0 ~ 250% Initial value: 80%
(3) StopTune E: Stop tune elevator
Cyclic stop tuning on the elevator axis. If the helicopter, after an elevator
flip, continues to coast, lowering "StopTune E" will create a harder stop
action to remove the coasting. If the helicopter continues to coast after
an elevator flip, lowering the "Stop tune E" will reduce this bounce.
Setting ranges: 0 ~ 250% Initial value: 80%
(4) HeadResp: Head Response
Head Response matches the gyro control speed to that which the heli-
copter is capable of reacting. In a standard helicopter a Head Response
of 1 should always be used, but on some scale applications, or uniquely
designed rotor heads, increasing head response might be needed to cure
over correction of the gyro.
Setting ranges: 1 ~ 10 Initial value: 1
(5) DeadBand: Dead band
Transmitter control dead band. If you are noticing inconsistent swash
plate drift or poor initialization it could be poor transmitter potentiom-
eter resolution. If you have to increase this value beyond 10.0, it is best
to check calibration on your transmitter.
Setting ranges: 0 ~ 25 Initial value: 4.0
(6) RESET : FLT tune data reset
This resets the "FLT.Tun" setting back to the defaults.
Cond
Cond
Cond
Cond