Curve setting examples
The curves shown below were created by using the Line
mode and inputting the data of the 5 points 0% (low
side), 25%, 50% (center), 75%, 100% (high) side at each
condition. They were created by reducing the number
points of the line to 5. When actually creating a curve,
The Throttle Hover function trims the throttle near
the hovering point. Normally, use it with hovering
changes in the temperature, humidity, and other flight
conditions can be trimmed. Adjust the throttle so that
rotor rotation is most stable. More delicate trimming is
also possible by using this function along with the Hover
Pitch function.
< Model Menu (Helicopter) >
183
Normal Curve
Idle-up 1 Curve
value).
Idle-up 2 Curve
Setting method
selected.
CTRM mode:
NORM mode:
center.
direction can be set.