Table of Contents
Advertisement
＜ Model Menu (Helicopter) ＞
206
Flight Tune（Aileron / Elevator Basic settings）
Flight Tune（Aileron / Elevator Basic settings）
(3) Cnt. AuthAIL: Control Authority Aileron
Aileron Control Authority changes the rate at which the gyro will try to
achieve the set "CYC. Rt". A higher value will create a quicker accelerated
reaction to a stick input to reach and stabilize to the "CYC. Rt" value; a
lower value will reach the desired "CYC. Rt" slower and accelerate slower
to the desired angular rate.
Note: Setting this value too high could lead to a jerky feeling when mak-
ing rapid stick corrections, a value too low will give you the impression
the model is not following the pilotʼ s stick inputs. Values of between
20-60 are the suggested range for most helicopters.
Setting ranges: 0 ~ 100%
Initial value: Cnt. AuthAIL = 40%
(4) Cnt. AuthELE: Control Authority Elevator
Elevator Control Authority changes the rate at which the gyro will try to
achieve the set "CYC. Rt". A higher value will create a quicker accelerated
reaction to a stick input to reach and stabilize at the "CYC. Rt" value; a
lower value will reach the desired "CYC. Rt" slower and accelerate slower
to the desired angular rate.
Note: Setting this value too high could lead to a jerky feeling when mak-
ing rapid stick corrections, a value too low will give you the impression
the model is not following the pilotʼ s stick inputs. Values of between
20-60 are the suggested range for most helicopters.
Setting ranges: 0 ~ 100%
Initial value: Cnt. AuthELE = 40%
(5) EXPO.: Exponential
Tune the exponential as desired to change the feel of the cyclic controls
around center stick. Negative values soften control feel; Positive values
increase sensitivity.
Note: that any exponential present in the TRANSMITTER adds to the
value set in the CGY.
Setting ranges: -100 ~ 0 ~ +100% Initial value: -20%
(6) FLT. Styl: Flight style
Increasing this value will create a more robotic reaction to the stick, leav-
ing the pilot with the impression that the model is locked into in a position
after an input. It will also tend to have a more calculated feeling when
making inputs.
-Lowering the value will make the model feel more fluid and easy to rotate
with the stick input. The model will feel a little more lively during faster cy-
clic movements and direction changes.
Setting ranges: 0 ~ +100 n Initial value: +50 n
Cond
Cond
Cond
Cond
Advertisement
Table of Contents
