Table of Contents
Advertisement
System type
■ FASSTest 26CH ---
■ FASSTest 18CH ---
■ FASSTest 12CH ---
Analog servos cannot be used with the FASSTest 12CH mode.
•
■ FASST MULTI ---
■ FASST 7CH --- FASST-7CH system receiver mode. Up to 7 channels can be used.
■ T-FHSS Air ---
■ S-FHSS --- S-FHSS system receiver mode. Up to 8 channels can be used.
● In the FASSTest26CH system, the channels that can be used on the S.BUS/S.BUS2 port are different.
・ S.BUS port : 1 - 16 channel
・ S.BUS2 port : 1 - 24 channel
When using channels 17 to 24 with S.BUS connection, connect the S.BUS2 servo to the S.BUS2 port of the receiver.
If the receiver of FASST and S-FHSS is used, the
methods of a link differ.
*Follow the manual of the receiver to be used.
Moreover, carry out an operating check.
＜ Linkage Menu ＞
85
FASSTest system receiver mode. Applicable with the telemetry sensor unit. Up to 26
channels (linear 24+ON/OFF2) can be used.
FASSTest system receiver mode. Applicable with the telemetry sensor unit. Up to 18
channels (linear 16+ON/OFF2) can be used.
FASSTest system receiver mode. Applicable with receiver voltage display. Up to 12
channels (linear10+ON/OFF2) can be used. Telemetry Sensor cannot be used, but the
response speed is faster than that of the 18CH mode.
FASST-MULTI system receiver mode. Up to 18 channels (linear 16+ON/OFF2) can be
used.
T-FHSS system receiver mode. Applicable with the telemetry sensor unit. Up to 18
channels (linear 16+ON/OFF2) can be used.
Advertisement
Table of Contents
