Table of Contents
Advertisement
In the "
" menu, you make the basic setting of the rudder gyro.
" screen from the "
"
WARNING
Do not connect the tail rotor servo to the gyro until the servo
type has been selected. Operating the servo using the incorrect
setting may damage the CGY or the servo.
Do not operate with the linkage connected until the "Srv.
Limit" function correctly sets the servo limit point. If the servo
operates beyond the linkage operating range, there is a danger
of either the servo or helicopter being damaged.
WARNING
When using the CGY for the first time, or when making mechanical
changes involving throw, you must check and set the servo limits again
to prevent binding.
＜ Model Menu (Helicopter) ＞
208
RUD Basic（Rudder GYRO Basic Setting）
RUD Basic（Rudder GYRO Basic Setting）
" screen.
(1) Servo Type
Select the appropriate setting for the tail rotor servo.
Setting: Analog / DG:1520 / DG760
Initial setting: DG:1520
DG 1520: BLS254, BLS257, S9254, S9257
DG 760: BLS276SV, BLS251SB, BLS251, S9256, S9251
(2) Gyro. Dir: Gyro direction
This parameter controls which direction the CGY (yaw axis) will compen-
sate when the helicopter rotates. Hold the tail rotor linkage over the
linkage ball on the servo, pick the helicopter up by the main shaft and
rotate the mechanics counter-clockwise. The CGY should compensate
by adding clockwise rotation pitch to the tail rotor blades. If the CGY
compensates by adding counter-clockwise rotation pitch to the tail rotor
blades, then it will be necessary to reverse the Compensation Direction
setting by pressing the "Gyro Dir".
Setting value: Normal / Reverse Initial value: Normal
(3) Work Mode: Gyro working mode
The available choices are CMT, Normal or AVCS. The CMT mode will allow
you to select either AVCS or Normal mode via the transmitter. In Normal
mode the gyro will always operate in Normal Rate Mode, and when AVCS
is selected, it will always operate in AVCS Mode.
Setting: CMT / Normal / AVCS Initial setting: CMT
(4) GY. Gain: Gyro base gain setting
This parameter sets the base gain of the gyro. This can be used to adjust
the gain % if your actual transmitter gain does not match the gain on the
CGY correctly.
Setting ranges: 0 ~ 150% Initial value: 100%
(5) Srv. Limit: Limit setting
When the CGY is in the "Srv.Limit" parameter mode, the gyro will no
longer operate and the tail servo will always center when the tail rotor
stick is released. Always exit the setup functions before attempting to fly
the model. Before each flight, always ensure that the gyros are operating
and compensating in the correct direction. The Servo Limit parameter
within the CGY is used to set the mechanical limits for the tail rotor servo.
To obtain the best performance it is recommended to set the limit in the
CGY to 100% for both directions and then adjust the servo arm length to
set the mechanical endpoints. After that has been completed, use the
servo limit parameter to make small adjustments that could not be made
mechanically. Values between 90% and 110% are considered optimal.
[ Setting method ]
Operate the rudder stick right or left in the direction you want to set.
Touch the button that is lit in green to set the limit. Do the same for the
other side.
WARNING
The servo type parameter within the CGY must
match the type of servo you are using. Incorrect set-
tings may damage the CGY or the servo. An incorrect
setting may also result in a loss of control during
flight.
Advertisement
Table of Contents
