Link procedure (T32MZ-WC ↔ R7208SB)
Linking method (T32MZ-WC ↔ R7208SB)
1. Bring the receiver to be linked to within 50 cm of
the transmitter.
Within 50 cm
2. Transmitter in link mode.
HOME Screen
3. The transmitter emits a chime sound and enters the
link mode.
4. The receiver power is immediately turned on.
About 2 seconds after the power is turned on the
receiver enters the linking state.
(Receiver linking time is about 1 second).
33
Link mode
5. If linking is successful, the receiver LED changes
from red to green, the link mode ends, and the
receiver ID code is displayed.
6. If linking fails, an error message is displayed. Bring
the transmitter closer to the receiver and repeat
the procedure above from step 2.
* Do not perform the linking operation when
the drive motor is connected or the engine is
running.
* When you use two receivers, please be sure to
setup a "primary" and "secondary" in the "dual"
mode.
* S i n c e t w o s e t s o f r e c e i v e r s c a n n o t b e
individually recognized without using a "primary"
and "secondary" setup, it is impossible to receive
telemetry data correctly.
* You must link one receiver at a time. If both
power supplies to the receivers are switched on
simultaneously, data is received incorrectly by
the transmitter.
* A telemetry function cannot be used for the 2nd
receiver.
*Only FASSTest26CH can be linked with 3 receivers.
In that case, select "Triple".
* Link is required when a system type is changed.
* Link is required when a new model is made from
a model selection.
WARNING
Do not perform the linking operation when the drive motor
is connected and the engine was started.
■ Inadvertent rotation of the motor or acceleration of the engine is
extremely dangerous.
Once the link operation is complete, please check that your
receiver can be operated with the linked transmitter.
Check operation sufficiently before flying after linking.
■ If the same receiver is sending in the vicinity, there is the danger that the
transmitter may be linked with that receiver.
CAUTION
Always turn on the transmitter power after linking is com-
plete.
When pairing with the transmitter, be sure that a previously
linked transmitter is not transmitting.
Rx ON