FUTABA 32MZ-WC Full Manual page 200

The " " screen is accessed via the "
Any unused functions should be set to INH (Inhibited). For example, if the Gain A/E and Gain RUD remote gain functions are not going to
The channel of each function
can be changed.
S. BUS connection: Condition on change channel
Using the methodology described previously, determine the "Cond CH #" and
set the condition change channel of the transmitter. In this example, DG1 is
the conditional change channel.
This resets the S.BUS channel assign-
ments back to the defaults.
Wireless channel
The wireless channel uses two consecutive channels. For example, if CH13 is
set to "# 1", CH14 is automatically set to "# 2". Therefore, when using this func-
tion, two consecutive free channels are required for the transmitter. It is not
possible to use a channel assign that is used for another function.
＜ Model Menu (Helicopter) ＞
200
S.BUS Basic Menu S.BUS Basic Menu
"
ELE2 channel Servo Type
(If you want to use the ELE2 port for purposes other than swash.)
This selects the ELE2 servo types. There are three types of the servo
driving frequency selection, AN:70 Hz, DG285 Hz, and 760 μ S. All
Futaba digital servos can be operated with fastest DG:285 Hz mode but
some of other brands of servos do not support DG:285 Hz mode. In this
case, select the proper servo driving frequency per the manufacturerʼ s
specifications.
If you select H4-00 or H4-45 with 4 servo swashes, cannot set this ELE2
port servo type. In that case, select all swash servo types in SWH basic
servo type.
Setting: AN:70 Hz / DG:760 μS / DG:285 Hz Initial setting: DG:285 Hz
WARNING
The servo type parameter within the CGY must match the type of
servo you are using. Incorrect setting may damage the CGY or the ser-
vo. Incorrect setting may also result in a loss of control during flight.
As with the flight condition function of the transmitter, it is possible to
utilize pre-determined settings, each activated by a switch or switches on
the transmitter. By setting the condition switch on the channel with the
AFR function of the transmitter and setting the point for each flight condi-
tion with the AFR point curve, you can switch the condition of CGY760R/
CGY755 in conjunction with the flight condition switch of the transmitter.
CAUTION
Be sure to check the operation for all conditions 1 to 5 before flying.
The setting of "wireless CH" is possible only when the transmitter and
the CGY are powered off and the CGY is turned on.
Be sure to connect and disconnect the CGY and T32MZ-WC connection
cable with the power off.
WARNING
Always verify that the S.BUS function as-
signments match your transmitterʼ s function
(in the FUNCTION menu) assignments. If any
changes are made within the transmitter func-
tion assignments, then it will also be necessary
to make the changes within the S.BUS function
assignments. To change the channel, CGY and
T32MZ-WC must be connected.
2 consecutive free channels