FUTABA 32MZ-WC Full Manual page 202

Hide thumbs Also See for 32MZ-WC:
Table of Contents

Advertisement

FRONT
H3-120
PIT
H4-00
PIT
AIL ------------------ Aileron servo
ELE ----------------- Elevator servo
PIT --------Collective pitch servo
ELE2 -----Second elevator servo
Your  transmitter  should  be  reset  to  the  default  settings  and  the  swash 
plate  type  selected  with  the  transmitter  should  be  set  to  "H-1"  or  single 
servo mode.  All CCPM mixing is set up and handled in the CGY, and the 
transmitter  functions  should  not  be  used.    Before  starting  model  set-
up, be sure that all dual rates, pitch curve, and endpoint values are set to 
100/100. 
(5) Servo Dir #: Servo direction #
Using  different  servo  combinations  will  create  the  proper  swash  plate 
servo  movement  in  electronic  CCPM  models  (eCCPM).    In  the  H3-xx 
swash mode, three of the swash servos directions are changed by press-
ing  the  Servo  Dir  #.    Choose  the  combination  number  which  produces 
level  swash  plate  travel  with  a  collective  pitch  input  from  the  transmit-
ter.  There are 8 combination choices for the H3-xx swash mode.  On H4-
xx  swash  mode,  there  are  16  combination  choices.    After  selecting  the 
combination  number,  aileron,  elevator,  pitch,  and  2nd  elevator  servo 
parameters are automatically set.
Note: Occasionally the aileron or elevator function directions are reversed 
even though collective pitch direction is correct.  In this case, use the "SWS.
Dir parameter on the following screen (4/6) to fix this later.
< Model Menu (Helicopter) >
202
Swash Basic
Swash Basic
H3-140
PIT
AIL
ELE
H4-45
ELE
ELE
AIL
PIT
ELE2
(4) SWASH Type: Swash change to plate type
Select the swash plate type.  When you change the setting, other data 
is initialized.
Setting: H-1 / H3-120 / H3-140 / H3-90 / H4-00 / H4-45   Initial setting: H3-120
WARNING 
  All  of  the  swash  plate  parameters  are  reset  when  the  swash  plate 
type is changed.  Doing so eliminates any possible errors or malfunc-
tions  within  the  system.  After  changing  the  swash  plate  type,  Please 
proceed through the entire setup process once again before attempt-
ing to fly the model.
H3-90
AIL
PIT
ELE
H-1
AIL
PIT
ELE2
Swash Type
H-1
AIL
ELE
AIL
ELE

Advertisement

Table of Contents
loading

Table of Contents