The swash detail setting is used to keep the swash plate level at high and low collective pitch to cyclic interactions and cyclic
pitch to collective pitch interactions. "
< Model Menu (Helicopter) >
217
SWH. Detail(Swash Detail Setting)
SWH. Detail(Swash Detail Setting)
" screen from the " EXPERT MENU 3D " screen.
(1) PIT
Going from MID to HIGH and MID to LOW collective pitch check that the
swash plate is traveling flat throughout the entire range.
[Setting method] Operate the transmitter stick in the direction you want
to set. Touch the button lit in green to enter the setting mode and adjust
the mixing rate. Do the same for the other side.
Setting ranges: 30 ~ 150% Initial value: 100%
(2) PIT
Going from MID to HIGH and MID to LOW collective pitch check that the
swash plate is traveling flat throughout the entire range.
[Setting method] Operate the transmitter stick in the direction you want
to set. Touch the button lit in green to enter the setting mode and adjust
the mixing rate. Do the same for the other side.
Setting ranges: 30 ~ 150% Initial value: 100%
(3) PIT
This parameter adjusts the pitch to 2nd elevator mixing rate. The rates
can both be adjusted individually for both full high and low collective po-
sitions. Note: This setting is only available if the H4-xx swash mode has
been selected.
Setting ranges: 30 ~ 150% Initial value: 100%
(4) AIL
At the middle collective pitch, check that during right to left and left to
right aileron action the swash plate is staying level on both the elevator
and collective pitch axis. If the swash plate is rising or falling with aileron
inputs.
[Setting method] Operate the transmitter stick in the direction you want
to set. Touch the button lit in green to enter the setting mode and adjust
the mixing rate. Do the same for the other side.
Setting ranges: 30 ~ 150% Initial value: 100%
(5) AIL
This parameter adjusts the aileron to elevator mixing rate. The rate can
be adjusted for left and right directions individually. Note: This setting is
only available if the H4-45 swash mode has been selected.
Setting ranges: 30 ~ 150% Initial value: 100%
(6) AIL
This parameter adjusts the aileron to 2nd elevator mixing rate. The rate
can be adjusted for left and right directions individually. Note: This set-
ting is only available if the H4-45 swash mode has been selected.
Setting ranges: 30 ~ 150% Initial value: 100%
AIL: collective pitch
aileron mixing rate
ELE: collective pitch
elevator mixing rate
ELE2: collective pitch
2nd elevator mixing rate
PIT: aileron
collective pitch mixing rate
ELE: aileron
elevator mixing rate
ELE2: aileron
2nd elevator mixing rate