Table of Contents
Advertisement
＜ Model Menu (Helicopter) ＞
218
SWH. Detail（Swash Detail Setting）
SWH. Detail（Swash Detail Setting）
(7) ELE
During back and forward elevator inputs at middle collective, check if the
swash plate is raising or lowering during the input.
[Setting method] Operate the transmitter stick in the direction you want
to set. Touch the button lit in green to enter the setting mode and adjust
the mixing rate. Do the same for the other side.
Note: This setting can not be used when H4-00 swash mode is selected.
Setting ranges: 30 ~ 150% Initial value: H3-120 = 50%, except H3-120 = 100%
(8) ELE
While moving the elevator back and forth at middle collective, check to
make sure the aileron axis is staying level.
[Setting method] Operate the transmitter stick in the direction you want
to set. Touch the button lit in green to enter the setting mode and adjust
the mixing rate. Do the same for the other side.
Note: This setting can not be used when H4-00 swash mode is selected.
Setting ranges: 30 ~ 150% Initial value: H3-120 = 50%, except H3-120 = 100%
(9) ELE
This parameter adjusts the elevator to 2nd elevator mixing rate. The rate
can be adjusted separately for up and down directions individually.
Note: This setting is only available if the H4-xx swash mode has been
selected.
Setting ranges: 30 ~ 150% Initial value: 100%
(10) AIL High / AIL Low: Linkage compensation aileron
At HIGH pitch and LOW pitch check to make sure that the swash plate
is staying level on the elevator and collective axis when using aileron
inputs. If the swash plate is rising or falling:
[Setting method] Operate the transmitter stick in the direction you want
to set. Touch the button lit in green to enter the setting mode and adjust
the mixing rate. Do the same for the other side.
Note: check all four directions: high/right; high/left; low/right; low/left
Setting ranges: 0 ~ 100% Initial value: 0%
(11) AIL Dir: Compensation direction of the aileron
If the above Data (+/-) correction from 0-100 is NOT in the correct com-
pensation direction, change the value from [+] or [-].
Setting: +/- Initial setting: +
PIT: elevator
collective pitch mixing rate
AIL: elevator
aileron mixing rate
ELE2: elevator
2nd elevator mixing rate
Advertisement
Table of Contents
