Battery Charging - FUTABA 32MZ-WC Full Manual

Battery Charging
1. Turn off the transmitter power.
2. Connect the power plug of the AC
adapter to an AC outlet.
*Don't connect AC plug to the T32MZ-WC
without connecting with an AC outlet.
3. Open the back lid of the transmitter and
insert the plug of the AC adapter into the
CHG port.
4. The charging monitor of the transmitter
lights red.
*In the case LCD screen will come on for
several seconds and then go off. It may
take several seconds for charging to start
after the AC adapter is connected.
5. When the battery is fully charged the
charge monitor will light off. Remove the
charge plug and AC adaptor.
* A f t e r u s i n g t h e A C a d a p t e r a l w a y s
disconnect the power cord from the AC
outlet.
* T h e t i m e t o c h a r g e a c o m p l e t e l y
discharged battery pack is approximately
4 hours. However, the actual charging
time may vary depending on temperature
and state of the battery.
*If the battery is improperly installed or is
faulty, the charging monitor will not light
and the battery will not charge.
Charging monitor
RED
OFF
Connect
AC first.
Choose the conversion
connector according to your
AC socket.
22
DANGER
The LT1F6600B lithium-polymer battery is for the T32MZ-WC trans-
mitter only. Do not use it with other devices.
Always use the included AC adapter to charge the battery. The
charging circuit is built into the T32MZ-WC.
WARNING
The transmitter battery cannot be charged with the receiver charger.
Conversely the receiver battery cannot be charged with the transmitter
charger.
Charging
Full charge
Connect the AC adapter
Up side