< Model Menu (Helicopter) >
214
RUD Expert(Rudder Gyro Expert Setting)
RUD Expert(Rudder Gyro Expert Setting)
(3) CNT. DlIn: Control delay in
This parameter sets the delay as you move the stick from neutral toward
left or right. Larger values result in a softer tail rotor feel off center. This
parameter must be adjusted individually for LEFT and RIGHT tail rotor
commands. Follow these same procedures to adjust the tail rotor feel in
the opposite direction.
[ Setting method ]
Move the transmitter Rudder stick right or left in the direction you want
to set. Touch the green button to enter the setting mode and set the de-
lay amount. Do the same for the other side.
Setting ranges: 0 ~ 20 n Initial value: 15 n
(4) CNT. DlOut: Control delay out
This parameter sets the delay when the stick is returned back to the
neutral position. This parameter is useful to tune how aggressively the
tail rotor stops following a pirouette. The higher the value, the softer the
stop. This parameter must be adjusted individually for LEFT and RIGHT
tail rotor commands. The setting method is the same as "CNT. DlIn", so
please refer to the information above.
Setting ranges: 0 ~ 20 n Initial value: 12 n
(5) ANG: Pirouette speed
This parameter adjusts the maximum pirouette speed of the tail rotor
that the gyro will allow at 100% dual rate.
Setting ranges: 100 ~ 999 d Initial value: = 720 d,