Table of Contents
Advertisement
Battery Charging
1. Turn off the transmitter power.
2. Connect the power plug of the AC
adapter to an AC outlet.
*Don't connect AC plug to the T32MZ-WC
without connecting with an AC outlet.
3. Open the back lid of the transmitter and
insert the plug of the AC adapter into the
CHG port.
4. The charging monitor of the transmitter
lights red.
*In the case LCD screen will come on for
several seconds and then go off. It may
take several seconds for charging to start
after the AC adapter is connected.
5. When the battery is fully charged the
charge monitor will light off. Remove the
charge plug and AC adaptor.
* A f t e r u s i n g t h e A C a d a p t e r a l w a y s
disconnect the power cord from the AC
outlet.
* T h e t i m e t o c h a r g e a c o m p l e t e l y
discharged battery pack is approximately
4 hours. However, the actual charging
time may vary depending on temperature
and state of the battery.
*If the battery is improperly installed or is
faulty, the charging monitor will not light
and the battery will not charge.
Charging monitor
RED
OFF
Connect
AC first.
Choose the conversion
connector according to your
AC socket.
22
mitter・only.・Do・not・use・it・with・other・devices.
charging・circuit・is・built・into・the・T32MZ-WC.
Conversely・the・receiver・battery・cannot・be・charged・with・the・transmitter・
charger.
Charging
Full charge
Connect the AC adapter
・DANGER
The・LT1F6600B・lithium-polymer・battery・is・for・the・T32MZ-WC・trans-
・ Always・ use・ the・ included・ AC・ adapter・ to・ charge・ the・ battery.・ The・
WARNING
The・transmitter・battery・cannot・be・charged・with・the・receiver・charger.・
Up side
→
GO to TABLE OF CONTENTS
Advertisement
Table of Contents
